● There is primer for Color Flon, 400°C resistant type, and 600°C resistant type.
● By painting a primer, the paint film contributes to improving corrosion, adhesive ability, and also the durability of standard coating will increase.
● In addition to the requirements of outdoor use, they can also be applied to the indoor surface if corrosion resistance is required.
Primer for Color Flon series 10G and 10F
Primer for Color Flon Rust ◆Heatproof temperature 200°C / Mat / Gray [JPMA No.FN-40] |
Primer for series 15, 405, 10 and series 300
900 ◆Heatproof temperature 400°C / Mat / Gray [JPMA No.FN-40] |
Primer for series 605, 500 and series 600
980 983 |
＊The above color numbering system is based on JPMA Standard Paint Colors. (F-Edition, 2011)
| 1.Surface Treatment | 2.Paint Agitation | 3.Painting | 4.Drying |
|---|---|---|---|
| Class 2 Keren and better | Dilution/ Stirring | Paint with brush or spray | Air dry for 24 hours or more (No baking) |
The process of top coating [＊1]
| 1.Stir of top coating | 2.Top coating | 3.Drying |
|---|---|---|
| Dilution / Mixing (Put a hardner into the paint if attached.) |
Paint with brush or spray | Air dry for 24 hours or more |
[＊1] Refer to the specification numerical value of the standard silver and the standard color.
[＊2] Air temperatures affect the drying time.The painted surface is dry to the touch but not completely cured.
(In order to bake completely, baking at 180°C for 20-30 minutes is required.)
Painted surface may become tacky and produce smoke, but in the mean time it will stop and be cured.
[＊Notice] Painting Conditions:Please abstain from painting under the condition below.
・When rainfall and snow are forecasted.
・When the outside temperature is under 5°C, and the difference with the dew point is within 3°C.
・When the relative humidity is 85% or more.
・When it is windy.
